PSF printer

If you want to use InfoPrint Select to submit print jobs with finishing options to a PSF printer, you must create a Select printer that uses the specific printer driver for your printer shown here. The driver is installed on your system when you install InfoPrint Select. Use the procedure that is described in the InfoPrint Manager for AIX: Getting Started guide for creating a Select printer, modifying it as described below.
  1. Follow the procedure through creating a port and selecting an InfoPrint destination.
  2. When the Add Printer wizard asks you to select a manufacturer and a printer model, do not select anything, just click Have Disk.
  3. In the Install from Disk dialog, click Browse and navigate to the directory that you installed InfoPrint Select in. The default directory is c:\Infoprint.
    Note: Because this dialog assumes the the driver is actually on a floppy disk or DVD-ROM, you might receive an error that the drive is not ready. In the error box, click Cancel. A Windows Open dialog should then open. Use that dialog to navigate to the correct directory.
  4. Select the Ibmprint.inf file and click Open.
  5. Select the appropriate driver based on your printer model and click OK.
    • For the InfoPrint 45 printer, specify the IBM AFP 4345 driver.
    • For the InfoPrint 60 printer, specify the IBM AFP 3160 driver.
    • For the InfoPrint 2000 printer, specify the IBM AFP 2710 driver.
  6. In the Install from Disk dialog, click Next.
  7. Complete the wizard as usual.

When you submit jobs to this printer, you can select the finishing option you want to use.

Note: The IBM InfoPrint 60 with Finisher driver only supports four finishing options: top corner, bottom corner, 2 edge stitch (two staples in one side of the paper), and 3 edge stitch (three staples on one side of the paper). If you need to use other finishing options, you have to use a different submission method.