Configuring to process jobs with FusionPro
After you configure the connection to FusionPro Server, set up input devices and the
RunFusionPro step template, then create a workflow that sends jobs to FusionPro for
processing.
- Add and enable a hot folder input device to receive FusionPro input files.
- Tune the RunFusionPro step template to run on the correct server:
- Click the Workflow tab.
- In the left pane, click Step Templates.
- Right-click the RunFusionPro step template and select Properties.
- On the Tuning tab, under Servers to use, select Run on specific servers, then select System.
- Add the RunFusionPro step template to a workflow.
- Click the Workflow tab.
- Open the workflow that you want to use to send jobs to FusionPro.
- In the workflow editor, click the side panel in the top right corner of the window.
- Go to Steps and expand the VARIABLE DATA group.
- Drag the RunFusionPro step into position and make sure it is connected to the workflow.
- Right-click the step and select Properties to see the properties and job defaults.
- Update the properties as needed. Refer to the ? help for additional information about each property.
- Click OK.
- Save the workflow.