Configuring to process jobs with FusionPro

After you configure the connection to FusionPro Server, set up input devices and the RunFusionPro step template, then create a workflow that sends jobs to FusionPro for processing.
To configure and to process jobs with FusionPro Server:
  1. Add and enable a hot folder input device to receive FusionPro input files.
  2. Tune the RunFusionPro step template to run on the correct server:
    1. Click the Workflow tab.
    2. In the left pane, click Step Templates.
    3. Right-click the RunFusionPro step template and select Properties.
    4. On the Tuning tab, under Servers to use, select Run on specific servers, then select the correct application server.
      Note:
    • If there are any changes regarding the FusionPro Server address, make sure to update the step template to use the resources from the new FusionPro server.
  3. Add the RunFusionPro step template to a workflow.
    1. Click the Workflow tab.
    2. Open the workflow that you want to use to send jobs to FusionPro.
    3. In the workflow editor, click the side panel in the top right corner of the window.
    4. Go to Steps and expand the VARIABLE DATA group.
    5. Drag the RunFusionPro step into position and make sure it is connected to the workflow.
    6. Right-click the step and select Properties to see the properties and job defaults.
    7. Update the properties as needed. Refer to the ? help for additional information about each property.
    8. Click OK.
    9. Save the workflow.

Related information:

Configuring RICOH ProcessDirector to work with FusionPro
Job processing fails in RunFusionPro step
FusionPro Connect
RunFusionPro
Parent topic: Setting up the FusionPro Connect feature