Job tab
- Proof
- If proof is required, select Proof Required, otherwise select No Proof Required.
-
Jobs that go through a Proof Approval process can have the following states:
- Awaiting Approval - A job is waiting for proof approval.
- Proof Approved - Proof is approved for a job.
- Proof Rejected - Proof for a job is rejected.
- Note:
- If Proof is set to No Proof Required, the system does not display any proof state.
- The information displayed is read-only. To change the proof state of a job manually, right-click a job from a list of jobs and select a proof state. You can also edit the job and modify the Proof attribute.
- Copies
- You can edit the number of copies to be printed.
Note: When jobs are sent for printing on an InfoPrint 5000 printer model, the maximum number of copies printed is limited to 32767.
- Pages
- You can edit the number of pages.
- Sheets
- The number of sheets cannot be edited and is determined by the system.
- Reprint Quantity
- The reprint quantity cannot be edited and represents the cumulative number of print copies that were sent for a job, except for the print proof copies.
- Document Page Width
- The width of the page.
- Document Page Height
- The height of the page.
- Color
- You can type in or select the color you want from a list.
- Pages per Side
- The number of pages on one side of the sheet. Specify a number of pages per one side. This field is mandatory.
- Imposition
- The description of pages arrangement on the printer’s sheet. You can describe the
value specified in the Pages per Side field. These are examples of the possible values:
- 1–Up
- 2–Up
- 3–Up
- 4 pager
- 8 pager
- 6pg Z-Fold
- Output Device
- Specify the digital printing press used for the job.
- 1-Sided/2-Sided
- You can choose one of these two options:
- 1-Sided
The simplex method allows printing on only one side of a sheet of paper.
- 2-Sided
The duplex method allows printing on both sides of a sheet of paper.
- 1-Sided
- Duplex Mode
- You can choose one of these options:
- Left Edge
- Top Edge
- Right Edge
- Bottom Edge
- Output Tray
- The Output Tray control allows you to configure the JDF options. Enter or select a supported JDF value from the list. If you select the default value, do not create an entry in the JDF file for the Output Tray. The Output Tray matches the Binding settings. Make sure that the requested device is available on the printer.
- Eject Output
- Specifies whether the output is ejected face down or face up in the Output Tray.
- Use default
- Uses the printer default settings.
- Face-down
- Select this option to eject the sheets starting with the first page facing down at the bottom of the stack.
- Face-up
- Select this option to eject the sheets starting with the first page facing up at the bottom of the stack.
- Face-down, reverse order
- Select this option to eject the sheets ending with the first page facing down on top of the stack.
- Face-up, reverse order
- Select this option to eject the sheets ending with the first page facing up on top of the stack.