Configuring and using cut-sheet emulation

To enable cut-sheet emulation, make sure that your printer has a microcode level of at least 9.216, then make sure that the appropriate personnel do these tasks at your installation on the systems specified:
  1. At the InfoPrint Linux server, the print administrator for your installation must disable the physical printer that you intend to run in cut sheet emulation mode.
  2. At the printer console, an operator must set the printer to cut-sheet emulation mode.
  3. The operator must then restart the printer.
  4. At the InfoPrint Linux server, the print administrator must create a logical printer for the physical printer.
  5. The print administrator must make sure that both the logical and physical printer has been enabled.
To submit a job, see "Using Cut Sheet Emulation."

In this section:

  1. Using cut sheet emulation
Parent topic: Administrative Procedures: Customizing for Special Jobs